ARB diameter RS133 Cup

[Rspt]

In process of ordering all suspension bushes from Powerflex via Ktec. Ktec don't list them but have been speaking to them and soon will if I can solve this little puzzle.........; Powerflex have three different diameter bushes listed for front anti roll bar chassis mount bush - 20,23 and 24mm. Lots of supposition/detective work going on in the meantime BUT does anyone know the measurements for sure??!

Any help massively appreciated. Thanks. RSPT

 

[Cup RS 133]

What car do you have a 133 ? As far as I'm aware the only powerflex bushes available are the rear beam bushes and arb bushes. All others dont fit the twingo 133 as it's a diffrent front end set up to the Clio & twingo GT etc. No idea what size the bushes are though.

 

[Rspt]

Thanks for reply mate. Yes it's a 59 plate 133cup (full Cup)

According to Powerflex website they stock:

https://www.powerflex.co.uk/road-series/products/Twingo+II+%282007+-+2014%29-3113/1.html

Ktec can't assertain ARB diameter and hence advise which of the three bush sizes to send.......

They advise I measure the ARB/bush..........

This was supposed to be a simple impulse purchase!!

 

[TheOnePC]

Go under the car with a caliper and measure the diameter...


Inviato dal mio iPad utilizzando Tapatalk

 

[Rspt]

Mechanic measured when in garage - reckons ARB diameter on rs133 cup is 20mm.

Front anti roll bar outer mount bush as advertised on Powerflex site is non applicable - RS uses different style

So as in reply above; lower wishbone bush, ARB chassis mount bush and rear beam bushes only ones applicable.

Thanks for responses.

 

[TheOnePC]

Mechanic measured when in garage - reckons ARB diameter on rs133 cup is 20mm.

Front anti roll bar outer mount bush as advertised on Powerflex site is non applicable - RS uses different style

So as in reply above; lower wishbone bush, ARB chassis mount bush and rear beam bushes only ones applicable.

Thanks for responses.

Not sure on lower wishbone. I think they only fit GT, not RS models


Inviato dal mio iPad utilizzando Tapatalk

 

[Cup RS 133]

Oh may I add the upper engine mount power flex insert fits from the Clio as well makes a good difference if you wedge the upper gearbox mount too.