Engine Movement

[neil_thomas82]

I wonder if anyone has this same issue?
I have fitted the k-tec full engine back exhaust. This was all good other than a broken lambda sensor plug..
On testing the car further the exhaust hits down on metal beam on the downward section b4 the cat.. I assume this is due to significant engine movement??
K-tec have been amazing with their guidance and have kindly offered to send me (free of charge) a lower engine support to see if this solves the problem.
Does anyone else have experience of this

 

[singlespeed]

Mines ok. However, I already had all three engine mounts upgraded. Upper two are Ktec/Vibratechnic ones and I made a new solid bush for the lower dogbone.

 

[neil_thomas82]

Here's where it's hitting. ..Theres a lot of space above the exhaust close to the heat shield but can hardly get hand between the beam and exhaust..

 

[neil_thomas82]

Pic didn't load last time oops :|