Problem with the bike HELP !!!!!!!

[Karl]

On the way home last night i didnt think much of it but its happened today aswell. when cycling with the chain on the small front when i stop pedaling the chain falls off i put it on the big front cog i dont have a problem any ideas?

 

[Matt]

Check the front mech cable, may need tightening/loosening.

 

[josh hatton]

Front mech hi/low points need adjusting. Along with cable,

Gear 1 at front, what gear are you in at the bck

 

[Karl]

Erm the middle to smallest

 

[josh hatton]

Don't know if you know, if your in granny ring, avoid the back cogs in
Smallest cog
Largest cog
The chain is not ment to strecH to far,

All it needs is a simple cable tension and high/low points looked at x

 

[Karl]

Super ill take it up the bike shop tomorrow

 

[Matt]

Adjust it yourself you pansy

Mech = derailleur btw.

 

[Karl]

I know what it is just dont know what to do :lol:

Ill leave it with the pros

 

[josh hatton]

Unless you know what your doing adjusting mechs is a hard job and most people end up making things 100x worse

 

[Karl]

Unless you know what your doing adjusting mechs is a hard job and most people end up making things 100x worse

I learnt my mistake trying to do a rear cassette and that could have cost me a bit i dismantled the wheel hub :lol:

Now leaving everything to the shop

 

[matbry01]

Take some links out the chain its a simpler way instead of putting a chain tentioner on I know my all about bikes

 

[matbry01]

And yes it needs adjusting the hi and low on it.

 

[Karl]

Shop is easyer :lol:

 

[TURBO]

Take some links out the chain its a simpler way instead of putting a chain tentioner on I know my all about bikes

top tip :lol: :lol:

 

[Karl]

Right the bikes repaied. Was the plastic chain gaurd behind the cassette that had broken lugs cause it to do what it liked :lol:

But at the same time they put new cables on the bike and new bar tape to finish it off.