Rear Arch Damage!

[Morgan]

Hey guys and girls. Well after allowing my brother to move my car out of the drive-way (i was drunk) has turned out worse. Clearly by the pictures to follow i could have done a better job in the state i was in!

My question to you is, Can i get just the arch on the rear bumper, or is a full bumper job.. if so it will be cheaper to respray.

Thanks all

 

[maggi200]

Isn't it a pearlescant finish on a dini? Could be a bitch to match but tbh I've no idea.

Looks nasty but could have been worse

 

[Morgan]

Well i didnt get a picture of the wall! That too it hard...fell over into the main road outside my house!

 

[singlespeed]

https://www.ebay.co.uk/itm/173-2010...arts_Vehicles_CarParts_SM&hash=item4ab0176d6c

 

[Morgan]

AGHHHH BINGO!!! ive been looking everywhere! Cheers pal... Next question any idea how to replace it?

 

[TripleJay]

ive got something similar on my front arch. Its a sole piece, no whole bumper neeed to be resprayed. Cost of my repair was 380,- €

 

[Morgan]

Yeah i noticed the front bumper is a solo piece.. but the rear isnt, having a look at them pictures looks like its just a case of clipping in on and off.. He says..

 

[TripleJay]

yeah, sorry, i meant NOT a sole piece of course front or rear, principle is the same..

 

[jra3d]

Should be an easy change mate. Speak to Karl Twingogekko see if he can get an exploded parts diagram too show where fixings may go.....

 

[maggi200]

I've got one somewhere

 

[Karl]

Get this

https://www.ebay.co.uk/itm/173-2010-Renault-Twingo-Gordini-RS-Offside-Rear-Bumper-Trim-Panel-Arch-/320781905260?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item4ab0176d6c

**EDIT**

Damn you beat me to it!

 

[maggi200]

Neil is toooo goood for you ....

Must be them fat fingers

 

[singlespeed]

AGHHHH BINGO!!! ive been looking everywhere! Cheers pal... Next question any idea how to replace it?

A quick snap of the back of the arch, it looks to be held on with clips which are pushed through the main bumper section. With the wheel off, it should be relatively easy to change.

Hose pipes frozen or it would be getting a wash now

Neil is toooo goood for you ....

Must be them fat fingers

hehe

 

[Oizo_133]

You need to take the whole back bumper down and then replace that part .. It's the same like they have done at Renault garage 14days ago .. had to change same part on my twingo because it went apart .. and it was 5mm space between the car and that part .. and they have replaced with new one .. there are some "click" parts ..

 

[jra3d]

Nice one oizo someone always holds the answer!