K&N apollo

shop deals on amazon
Shop deals on ebay
Advertise with us
Twingo Forum

Help Support Twingo Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
yeah mate you can stick it anywhere, aslong as the original breather hose is still able to connect onto the new inlet you've made so it can be behind it out of view if you wish :)
 
no no, i meant the breather hose that's already there on the original inlet hose lol
 
awesome mate, don't be scared to hack a snug fit hole into the back of it, it'll be out of sight and will save you a shit load of money :)

remember that you want the hole to be a bit smaller than the 25mm breather pipe connector you are putting in so that you can push it in & then seal it with the resin. if you do make the hole say around 22-23 mm, you may even find that you might not even need the resin but a little dab won't do any harm. it won't be going anywhere fast that's for sure. feel free to take a couple of pictures and make a how to ;)

if you get stuck, give me a shout
 
well there you go, i didn't know it came with that? martins didn't, weird! anyway that appears to be a breather pipe? there should be some adapters that came with it, anything close to 25mm ?? i don't quite think the original breather hose would reach that far though i may be wrong?!?! hopefully there is a blanking option so that you can soldier on with hiding the breather
 
try that big fat one first, tighten down the hose clamp onto it so that it compresses the hose around it. one of them is a blanking screw am i correct (in the sense that it shuts the hole off to prevent air getting in?) if it is a blanking screw then put that in and just continue on with the previous plans. if there are no blanking screws, just take one of the adapters down to a tool shop motor factors place and ask for a bolt in the same thread size roughly the same thread length and stick that in. this will definitely get rid of that hole.


if youuu gettt meee? :)
 
Omg this bring sounds unreal!!! I have kept the oem hose in atm because I didn't have time to cut my new 90 degree hose but I will get round to it! I will perhaps post something so you guys can see what like :)
 
Top