sam666
Well-known member
you could of saved your self £50 if you had waited another week and got the k-tec one 
.
.
Martin's Red GT
- Thread starter Martin_172
- Start date
Help Support Twingo Forum:
Martin_172
Well-known member
im not a ktec fan, tbf this things been ordered for months, but the guy making it cut his finger off (no joke!!) so it was massively delayed lol!!
Martin_172
Well-known member
Fitted the decat today, what a pain, I didn't want to remove the driveshaft and have to drain the gearbox oil so I just removed the bottom engine mount and rocked the engine back and forward, cut myself to pieces etc!! im not touching the pipe again after that, going to have the mid section between the centre section and downpipe flanged and a custom pipe with a cat made up so I can swap over at mot time!
videos to come tonight hopefully but so far it sounds pretty good bit raw and farty but I imagine it will carbon up a bit and sound better, cars flying though!!
videos to come tonight hopefully but so far it sounds pretty good bit raw and farty but I imagine it will carbon up a bit and sound better, cars flying though!!
MovingShadow
Well-known member
Very nice! :clap:
Curious for the results!
Curious for the results!
Martin_172
Well-known member
Should be back on the same rollers as last time, only result ive got so far is ive got an airstrip i like to test my top speed on my cars on, keeps it consistent using the same one and every time ive tried in the twingo since map it does 118mph, tonight it done 120mph lol
Martin_172
Well-known member
Yeah noticably better as it comes on boost, mid range feels the same and above 4500rpm feels much better
sam666
Well-known member
flames ?????
Martin_172
Well-known member
Not had anyone following me yet so not sure!
waitey
Well-known member
what gains are you expecting?
Martin_172
Well-known member
mate who wrote off his car offered me an offer I couldn't refuse tonight so the twingo is now SOLD!!!!!!
going back to standard tomorrow morning and leaving me in the afternoon!
all bits going up for sale in the section tomorrow, coilovers, spacers, panel filter, decat, head unit, sub, amp the lot!!!
my next project is building a 300bhp Turbocharged clio 172
going back to standard tomorrow morning and leaving me in the afternoon!
all bits going up for sale in the section tomorrow, coilovers, spacers, panel filter, decat, head unit, sub, amp the lot!!!
my next project is building a 300bhp Turbocharged clio 172
sam666
Well-known member
ill give you a £100 for the decat pipe lol
Martin_172
Well-known member
yeah dude ill be sticking around! probably end up with another twingo at some point for my mrs.
£100?! id rather stick it on my fire place its a work of art!
£100?! id rather stick it on my fire place its a work of art!
sam666
Well-known member
yh i was thinking you would say that lol it's worth a tryMartin_172":lihe4ypa said:
Martin_172
Well-known member
Just bought a ph2 flame red 172 for 1300 quid, here goes moneypit time
MovingShadow
Well-known member
Hope you can still answer this Martin, but you said place the decat and then a cat in between the decat and the backbox for when you need to go to MOT.
Like the Twingo RS, do you need to extend the sensors/wires for when installing the cat or is it different for the GT?
Also, doesn't the lambda sign jump on when installing the decat?
Like the Twingo RS, do you need to extend the sensors/wires for when installing the cat or is it different for the GT?
Also, doesn't the lambda sign jump on when installing the decat?